Coal bunker wear-resistant lining has wear resistance, high impact strength, shock absorption, flame retardant, antistatic, self-lubricating, chemical corrosion resistance, shielding atomic radiation, low temperature resistance (-256 ℃), non-toxic, non-polluting, etc. characteristics, and has machinability.
The use of ultra-high molecular weight polyethylene sheet has certain requirements on the material's wear resistance, chemical corrosion resistance, low friction coefficient, flame retardant and antistatic, high impact strength, ultra-low temperature performance, long-term use performance and environmentally friendly, non-toxic and odorless. On occasions, ultra-high is the first choice.
Our factory is a manufacturer specializing in the production of coal bunker linings. Because coal bunker linings have many excellent characteristics, most of them at home and abroad use this material to make linings.
Today we are going to introduce to you the forming method of coal bunker lining. There are two common molding methods for the lining of coal bunker linings. There are two common methods: compression molding and machining. Good, but the coal bunker lining has a shrinkage phenomenon.
Ultra-high molecular weight polyethylene board has been gradually widely used, so what matters should be paid attention to during storage of ultra-high molecular weight polyethylene board, the technical staff will give you a detailed introduction: The temperature and humidity of the warehouse can ensure the stability of the quality of the ultra-high molecular weight polyethylene board, and the change of the temperature and humidity of the warehouse is directly affected by the natural climate change outside the warehouse.
Therefore, we must not only be familiar with the characteristics of ultra-high molecular weight polyethylene sheets, but also master the changing laws of natural climate and the influence on the temperature of the warehouse, so as to properly control the temperature of the warehouse, improve the storage environment of commodities, and ensure the safety of commodity quality.